Just to clarify, the error message isn’t listed at all on the Details tab, but shows up as an issue in the Issue Summary tab? I’ll take a look later today and see if there’s any obvious issue that might cause this, and if not I’ll contact you separately about the report.
I recently ran an validation check and got this error message which seems correct. SD0037 was identified as an issue as = “Value for ARM not found in ARM user-defined codelist”. This looks good to me. However when I navigate to the Details tab the issue and dataset was not identified. So to get all the relevant details I have to toggle back between these 2 sheets. It seems that the error should be present in the Details tab if it is present in the Issue Summary tab but it is not. Can you explain this / look into this further? If you need a copy of the report you can contact me off list.